Online Electronics Test - Electronics Test 1

Instruction:

  • This is a FREE online test. Beware of scammers who ask for money to attend this test.
  • Total number of questions: 20.
  • Time allotted: 30 minutes.
  • Each question carries 1 mark; there are no negative marks.
  • DO NOT refresh the page.
  • All the best!

Marks : 2/20


Total number of questions
20
Number of answered questions
0
Number of unanswered questions
20
Test Review : View answers and explanation for this test.

1.
1300 × 10–12 F is the same as 1300 ___.
mF
mu.gifF
nF
pF
Your Answer: Option
(Not Answered)
Correct Answer: Option

2.
If a 220 omega.gif, a 100 omega.gif, and a 180 omega.gif resistor are connected in series across a 12 V source, the circuit current equals ___.
41.67 A
120 mA
500 A
24 mA
Your Answer: Option
(Not Answered)
Correct Answer: Option

3.
The total power dissipated is 4.8 watts.

True
False
Your Answer: Option
(Not Answered)
Correct Answer: Option

4.
The rms voltage value is a measure of a sine wave's heating effect.
True
False
Your Answer: Option
(Not Answered)
Correct Answer: Option

5.
A capacitor has 25 V across its plates and a stored charge of 1500 mu.gifC. What is the capacitance value?
60 pF
60 mu.gifF
16.67 mF
37.5 mF
Your Answer: Option
(Not Answered)
Correct Answer: Option

6.

The phase angle in the circuit in the given circuit is approximately equal to ______.

53°
90°
37°
Your Answer: Option
(Not Answered)
Correct Answer: Option

7.

What is the voltage across the capacitor in the given circuit?

6.8 V
11.9 V
16.1 V
22.9 V
Your Answer: Option
(Not Answered)
Correct Answer: Option

8.

What is the resonant frequency in the given circuit?

11.6 Hz
275.8 Hz
1.5 kHz
3.2 kHz
Your Answer: Option
(Not Answered)
Correct Answer: Option

9.
By increasing the resistance of a coil you can increase the Q of the coil at resonance.
True
False
Your Answer: Option
(Not Answered)
Correct Answer: Option

10.

The output voltage is _____ at the resonant frequency in the given circuit.

0 mV
31.4 mV
66.5 mV
380 mV
Your Answer: Option
(Not Answered)
Correct Answer: Option

11.
The depletion-mode MOSFET
can operate with only positive gate voltages
can operate with only negative gate voltages
cannot operate in the ohmic region
can operate with positive as well as negative gate voltages
Your Answer: Option
(Not Answered)
Correct Answer: Option

12.
A circuit whose output is proportional to the difference between the input signals is considered to be which type of amplifier?
common-mode
darlington
differential
operational
Your Answer: Option
(Not Answered)
Correct Answer: Option

13.
Changing the input voltage to an op-amp circuit will change its voltage gain.
True
False
Your Answer: Option
(Not Answered)
Correct Answer: Option

14.
A two-pole high-pass active filter would have a roll-off rate of
40 dB/decade
–40 dB/decade
20 dB/decade
–20 dB/decade
Your Answer: Option
(Not Answered)
Correct Answer: Option

15.
The power rating of a resistor is __________ related to __________.
directly, the type of cooling used
indirectly, the type of material used
directly, its surface area
indirectly, the color coding
Your Answer: Option
(Not Answered)
Correct Answer: Option

16.
How will electrons flow through a p-channel JFET?
from source to drain
from source to gate
from drain to gate
from drain to source
Your Answer: Option
(Not Answered)
Correct Answer: Option

17.
Which type of signal is represented by discrete values?
noisy signal
nonlinear
analog
digital
Your Answer: Option
(Not Answered)
Correct Answer: Option

18.
Once a PAL has been programmed:
it cannot be reprogrammed.
its outputs are only active HIGHs
its outputs are only active LOWs
its logic capacity is lost
Your Answer: Option
(Not Answered)
Correct Answer: Option

19.
What happens to the parallel output word in an asynchronous binary down counter whenever a clock pulse occurs?
The output word decreases by 1.
The output word decreases by 2.
The output word increases by 1.
The output word increases by 2.
Your Answer: Option
(Not Answered)
Correct Answer: Option

20.
The data stored in a Mask ROM (MROM) is ___________.
permanent
volatile
erasable
temporary
Your Answer: Option
(Not Answered)
Correct Answer: Option

*** END OF THE TEST ***
Time Left: 00:29:56
Post your test result / feedback here: