Civil Engineering - RCC Structures Design - Discussion
Discussion Forum : RCC Structures Design - Section 4 (Q.No. 17)
17.
Lapped splices in tensile reinforcement are generally not used for bars of size larger than
Discussion:
15 comments Page 1 of 2.
Yamanoor said:
9 years ago
Lap splicing of reinforcement bar more than 36mm in diameter should be avoided. In case such bars have to be lapped then they should be welded. When welding of cold bars is allowed, the special instructions applicable to these bars should be followed.
Yash Patel said:
3 years ago
As per the revised amendment of 2013, there is no revision of clause 26.2.5.1.
So it's false. Check it out.
So it's false. Check it out.
Saddam said:
7 years ago
As per clause 26.5.1(a) of IS-456-2000, Lap Splices shall not be used for bars larger than 36 mm.
Hemant said:
7 years ago
When bar dia greater than 36mm then lapped not used, welding is used.
(1)
Sahil Chavda said:
5 years ago
Tensile reinforcement -36 mm.
Compression reinforcement- 30 mm.
Compression reinforcement- 30 mm.
Soudipacharya said:
5 years ago
Absolutely correct @Furqan.
It is according to IS 456:2000.
It is according to IS 456:2000.
Saurabh said:
5 years ago
Before 4th (2013) amendment it was 36 now it's 32.
(1)
Mohammed Furqan said:
6 years ago
Before amendment 4 it was 36.
Now it's 32mm.
Now it's 32mm.
(1)
Ayon said:
7 years ago
Yes, it is 36 mm as per clause 26.2.5.1(a).
Vijay said:
8 years ago
By which clause, The answer is 36?
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers