Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 1 (Q.No. 3)
3.
If the diameter of the hole is subject to considerable variation, then for locating in jigs and fixtures, the pressure type of locator used is
Discussion:
13 comments Page 2 of 2.
Venkatesh said:
7 years ago
Explain pressure type of locators in jigs and fixtures.
(1)
Mohit sharma said:
6 years ago
1. Conical locator is used for locating the workpieces having a cylindrical hole in the workpiece. The workpiece is found located by supporting it over the conical locator inserted into the drilled hole of the workpiece.
2. Vee locator is used for locating the circular and semi-circular type of Workpieces.
3. Cylindrical locator is used for locating components.
Having drilled holes. The cylindrical component to be located is gripped by a Cylindrical locator fitted to the jig's body and inserted in the drilled hole of the Component.
2. Vee locator is used for locating the circular and semi-circular type of Workpieces.
3. Cylindrical locator is used for locating components.
Having drilled holes. The cylindrical component to be located is gripped by a Cylindrical locator fitted to the jig's body and inserted in the drilled hole of the Component.
(10)
Aaki said:
5 years ago
Vee locators also best for holding material.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers