Mechanical Engineering - Production Engineering - Discussion

Discussion Forum : Production Engineering - Section 1 (Q.No. 3)
If the diameter of the hole is subject to considerable variation, then for locating in jigs and fixtures, the pressure type of locator used is
conical locator
cylindrical locator
diamond pin locator
vee locator
Answer: Option
No answer description is available. Let's discuss.
13 comments Page 1 of 2.

Aaki said:   4 years ago
Vee locators also best for holding material.

Mohit sharma said:   5 years ago
1. Conical locator is used for locating the workpieces having a cylindrical hole in the workpiece. The workpiece is found located by supporting it over the conical locator inserted into the drilled hole of the workpiece.

2. Vee locator is used for locating the circular and semi-circular type of Workpieces.

3. Cylindrical locator is used for locating components.

Having drilled holes. The cylindrical component to be located is gripped by a Cylindrical locator fitted to the jig's body and inserted in the drilled hole of the Component.

Venkatesh said:   6 years ago
Explain pressure type of locators in jigs and fixtures.

Narri said:   6 years ago
Why vee locator doesn't used, can anyone explain?

Vikash Sindhania said:   7 years ago
Diamond is also a hard material and good strength but at any situation it breaks then it become too costly to purchase. As compared to another tool.

Gokul said:   7 years ago
Why Diamond locator cannot be used? Please explain it.

Onkar said:   7 years ago
What is the difference between conical and diamond locator?

Why diamond locator not use? I think it's also usable in this situation.

Sanjeev said:   8 years ago
Conical locators are used TP center work piece and are used for rough bore location.

Rahul sharma said:   9 years ago
Conical pins provides line contact and recommended for work pieces with varying hole size.

Krushna.phuke said:   9 years ago
Conical locator is locate the proffer.

Post your comments here:

Your comments will be displayed after verification.