Mechanical Engineering - Engineering Materials - Discussion
Discussion Forum : Engineering Materials - Section 3 (Q.No. 36)
36.
In process annealing, the hypo-eutectoid steel is
Discussion:
11 comments Page 1 of 2.
HAREESH said:
8 years ago
Annealing is two types.
1. Full annealing (upper critical temp).
2. Process annealing (LOWER CRITICAL TEMP).
1. Full annealing (upper critical temp).
2. Process annealing (LOWER CRITICAL TEMP).
(2)
Dibakar Borah said:
9 years ago
No, the answer is wrong. The answer is C.
I am 100%. Because in annealing process Hypoeutectoid steel (8% carbon) is headed to 30 degree celsius to 50 degree celsius above the upper critical tempered and cool in the furnace itself by switching off the furnace or the steel is covered either in sand or dry lime and dry ash.
I am 100%. Because in annealing process Hypoeutectoid steel (8% carbon) is headed to 30 degree celsius to 50 degree celsius above the upper critical tempered and cool in the furnace itself by switching off the furnace or the steel is covered either in sand or dry lime and dry ash.
(1)
Sanjeev kumar said:
8 years ago
It is the process of annealing hence the answer is correct.
Answer is D.
Answer is D.
(1)
Mohit Bora said:
9 years ago
The question isn't about annealing. It's about "process annealing" aka low-temperature annealing. And in this process metal is heated below low critical temperature. Generally 550-650 degree Celcius. So and is (d) my brother BORAH.
Santosh said:
9 years ago
I hope the answer is wrong.
And the correct answer is option C.
And the correct answer is option C.
Tejaswini said:
9 years ago
Option C is correct for 'full annealing'.
Ketan said:
8 years ago
Right @Tejaswini.
If "full annealing" is here, than it will be option 'c'.
If "full annealing" is here, than it will be option 'c'.
Raisahab said:
6 years ago
Answer C is correct because in annealing metal is cooled very slowly in the furnace.
Ankit said:
6 years ago
For annealing process -temp below or close to the LCT, so D option is right.
Ref: RS Khurmi.
Ref: RS Khurmi.
Prathmesh Jamdade said:
6 years ago
No. Answer is wrong because Annealing is done furnace itself only.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers