Mechanical Engineering - Engineering Materials - Discussion
Discussion Forum : Engineering Materials - Section 3 (Q.No. 36)
36.
In process annealing, the hypo-eutectoid steel is
Discussion:
11 comments Page 1 of 2.
Rajendra said:
5 years ago
Annealing is not only one process and it contains more.
In that full annealing, process annealing, etc.
So in this question, option D is correct.
In that full annealing, process annealing, etc.
So in this question, option D is correct.
Prathmesh Jamdade said:
6 years ago
No. Answer is wrong because Annealing is done furnace itself only.
Ankit said:
6 years ago
For annealing process -temp below or close to the LCT, so D option is right.
Ref: RS Khurmi.
Ref: RS Khurmi.
Raisahab said:
6 years ago
Answer C is correct because in annealing metal is cooled very slowly in the furnace.
HAREESH said:
8 years ago
Annealing is two types.
1. Full annealing (upper critical temp).
2. Process annealing (LOWER CRITICAL TEMP).
1. Full annealing (upper critical temp).
2. Process annealing (LOWER CRITICAL TEMP).
(2)
Sanjeev kumar said:
8 years ago
It is the process of annealing hence the answer is correct.
Answer is D.
Answer is D.
(1)
Ketan said:
8 years ago
Right @Tejaswini.
If "full annealing" is here, than it will be option 'c'.
If "full annealing" is here, than it will be option 'c'.
Tejaswini said:
9 years ago
Option C is correct for 'full annealing'.
Santosh said:
9 years ago
I hope the answer is wrong.
And the correct answer is option C.
And the correct answer is option C.
Mohit Bora said:
9 years ago
The question isn't about annealing. It's about "process annealing" aka low-temperature annealing. And in this process metal is heated below low critical temperature. Generally 550-650 degree Celcius. So and is (d) my brother BORAH.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers