Civil Engineering - Waste Water Engineering - Discussion

Discussion Forum : Waste Water Engineering - Section 4 (Q.No. 48)
You are asked to design sewer pipes of diameters 0.4 m to 0.9 m at maximum flow, you will assume the sewer flow running at
full depth
half full
two third full
three fourth full.
Answer: Option
No answer description is available. Let's discuss.
14 comments Page 1 of 2.

S~Khattak said:   3 years ago
The Correct option is two-thirds full.

==> if D<4 then half full,
==> if 0.4<D<0.9 then two-third full,
==> if D> 0.9 then three-fourth full.

Gayatri sangale said:   3 years ago
Yes, it's 2/3rd.

Deepak G S said:   8 years ago
It's two-third full.

up to 0.4m - half full.

0.4 to 0.9 - two third.

Greater than 0.9m - three-fourth full.

Saunak said:   8 years ago
You are absolutely correct @Deepak.

Davinder saini said:   8 years ago
As per my knowledge it is two-third full.

Karthik said:   7 years ago
I think it is two third full.

Mahim said:   7 years ago
It is 2/3 full.

Digneshsoni said:   6 years ago
It is 2/3 for full.

Chauhan said:   6 years ago
Answer is 2/3 full.

Kajol said:   6 years ago
Yes, correct @Deepak.

The answer should be two-third full.

Post your comments here:

Your comments will be displayed after verification.