Civil Engineering - Highway Engineering - Discussion
Discussion Forum : Highway Engineering - Section 6 (Q.No. 2)
2.
Thickness of broken centre line markings for a four lane road, is generally kept
Discussion:
11 comments Page 1 of 2.
Timir Daata said:
12 months ago
According to IRC 35 2015, the centre line marking of a four-lane undivided road will be LM02, LM12 or LM24 respectively as per the zone of the highway. The question is wrong, as thickness is measured in mm, it should alternatively have been 'length' instead.
So, the correct answer would have been 3 m, with a gap 6 m and a width of 150 mm.
So, the correct answer would have been 3 m, with a gap 6 m and a width of 150 mm.
Dpaul said:
5 years ago
On undivided urban roads with at least two traffic lanes in each direction, the centre line marking may be a single solid line of 150 mm wide and side line marking are 100 mm wide.
Srinadh said:
7 years ago
The centre line may be single broken line segments of 3m long and 150 mm wide for 4 lane roads and these broken lines are placed with 4.5 m gaps.
Engr. Niazi said:
5 years ago
For a 4-Lane road,
Width of broken road marking = 15 cm.
Length of these markings = 1.5 m,
Distance between these markings = 3 m.
Width of broken road marking = 15 cm.
Length of these markings = 1.5 m,
Distance between these markings = 3 m.
(1)
Manish said:
7 years ago
10cm is the answer, 15 cm is not for four lane check this address.
Hari said:
4 years ago
The Correct answer is 15cm. Agree with the given answer.
(1)
Durgesh Nemade said:
4 years ago
Thermoplastic paint havinh thickness only 1.8 mm.
Vivek mishra said:
6 years ago
No, its 10 cm length 3m and gap 4.5 m.
Naveed said:
6 years ago
Not thickness but width kept 15cm.
Krishna said:
6 years ago
What should be the correct answer?
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers