Civil Engineering - Estimating and Costing - Discussion
Discussion Forum : Estimating and Costing - Section 1 (Q.No. 1)
1.
Pick up the excavation where measurements are made in square metres for payment.
Discussion:
22 comments Page 1 of 3.
Gowher maqbool said:
7 years ago
Excavation exceeding 1.5 m in width, as well as IO m^2 on plan but not exceeding 300 mm in depth, shall be described as 'surface excavation' and measured in square metres.
Trimming of ground surface to remove small inequalities not exceeding I50 mm deep shall be described as surface dressing and measured in square metres.
Trimming of ground surface to remove small inequalities not exceeding I50 mm deep shall be described as surface dressing and measured in square metres.
(3)
Vaxoo said:
3 years ago
Surface dressing is by default measured in m2.
For excavation of width>1.5m and depth<30cm measured in m2.
For excavation of width>1.5m and depth<30cm measured in m2.
(2)
Kishan said:
5 years ago
Excavation up to 30 cm measured in sqm.
Excavation more than 30cm measured in cubic m.
Excavation more than 30cm measured in cubic m.
(1)
Er muqeem said:
7 years ago
How to measure place in square meter?
(1)
Satish deore said:
8 years ago
Excavation up to 30 cm is measured in sq m and if it is greater than 30 cm then it is measured in the cubic meter.
(1)
Khandeshwar said:
8 years ago
Thanks @Satish.
Arjun acharya said:
4 years ago
I think option 1 is also right.
Shalini said:
6 years ago
Yes, right. Thanks @Maqbool.
Mithun said:
6 years ago
Thanks @Gowher.
Rabindra said:
7 years ago
Thanks @Satish.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers