Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 7 (Q.No. 3)
3.
In order to achieve a specific surface finish in single point turning, the most important factor to be controlled is
Discussion:
12 comments Page 1 of 2.
UDAY said:
8 years ago
Surface finish value Ra += F^2 / 8R.
F-feed.
R-nose radius.
So the answer is FEED.
F-feed.
R-nose radius.
So the answer is FEED.
(1)
Sachin said:
9 years ago
I think it should be option c.
As finish depends on the feed of tool.
As finish depends on the feed of tool.
Milind sardar said:
9 years ago
In a single point, the cutting tool surface finishes control by feed and nose radius.
RAVI AGARWAL said:
9 years ago
We know that the surface roughness is directly proportional to square of feed.
So in order to achieve specific surface finish we should control on feed instead of cutting velocity. Therefore, Its answer is option C.
So in order to achieve specific surface finish we should control on feed instead of cutting velocity. Therefore, Its answer is option C.
Rohit said:
9 years ago
It should be feed.
Mr Bhol said:
8 years ago
Practical experiment indicates that machining parameter that had the highest influence on surface roughness is the feed rate followed by the cutting speed and the depth of cut.
Bhol said:
8 years ago
Surface roughness directly proportional to the square of feed rate.
Mr Bhol said:
8 years ago
Here all 3 may be correct like feed, cutting speed, depth of cut while machining practically.
Like by. Reduce the depth of cut, increase speed and reduce feed to get a better finish on job.
Like by. Reduce the depth of cut, increase speed and reduce feed to get a better finish on job.
Obak said:
8 years ago
Feed will be the correct answer.
Tech guru said:
7 years ago
C. Feed should be the correct answer.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers