IndiaBIX

Mechanical Engineering - Production Engineering - Discussion

Discussion Forum : Production Engineering - Section 1 (Q.No. 29)
Production Engineering
29.
The facing is an operation of
bevelling the extreme end of a workpiece
embossing a diamond shaped pattern on the surface of a workpiece
reducing the diameter of a workpiece over a very narrow surface
machining the ends of a workpiece to produce a flat surface square with the axis
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Discussion:
5 comments Page 1 of 1.
Ganeshr said:   5 years ago
@Raj.

Very good, thanks.
Raj said:   6 years ago
Option A -> beveling or chamfering.
Option B -> knurling.
Option C -> grooving.
Option D -> facing.
(3)
Hari said:   7 years ago
Facing is done to produce flate cross-sectional surface. Tool mounted at 45°.
(1)
Dhanasekaran said:   10 years ago
Facing is the operation which is to reduce length of the component whereas turning is to reduce diameter of the component.
(1)
Rakesh said:   10 years ago
Facing Operation is done on the Lathe machine by adjusting tool post angle. At 45 Deg. This operation is done to get the good flat surface it may be cylindrical or square work piece.
(1)
Post your comments here:

Your comments will be displayed after verification.

Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers