IndiaBIX

Mechanical Engineering - Production Engineering

Exercise : Production Engineering - Section 1
26.
A fixture does not guide the tool.
Correct
Incorrect
Answer: Option
Explanation:
No answer description is available. Let's discuss.
27.
Crater wear occurs mainly on the
nose part, front relief face and side relief face of the cutting tool
face of the cutting tool at a short distance from the cutting edge only
cutting edge only
front face only
Answer: Option
Explanation:
No answer description is available. Let's discuss.
28.
Gear lapping is an operation
after heat treatment
prior to heat treatment
for gear reconditioning
none of these
Answer: Option
Explanation:
No answer description is available. Let's discuss.
29.
The facing is an operation of
bevelling the extreme end of a workpiece
embossing a diamond shaped pattern on the surface of a workpiece
reducing the diameter of a workpiece over a very narrow surface
machining the ends of a workpiece to produce a flat surface square with the axis
Answer: Option
Explanation:
No answer description is available. Let's discuss.
30.
A fixture is defined as a device which
holds and locates a workpiece and guides and controls one or more cutting tools
holds and locates a workpiece during an inspection or for a manufacturing operation
is used to check the accuracy of workpiece
all of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers