Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 1 (Q.No. 24)
24.
Side rake angle on tools is provided to control chip flow.
Discussion:
15 comments Page 1 of 2.
Ayan said:
1 decade ago
Increase in the SRA reduces the chip thickness in turning.
KARAN said:
1 decade ago
The chip increase the SRA and the chip reduces the turning thickness.
Karthik said:
10 years ago
I think answer is wrong, control of chip flow depends upon the Back rake angle.
Siddharth said:
9 years ago
You are right @Karthik.
Vilas said:
9 years ago
Control of chip flow depends upon the Back rake angle.
Vishal said:
8 years ago
Yes, back rake angle.
KOTI SRINUBABU said:
8 years ago
My opinion also same. Because side rake angles are relief angles to prevent rubbing action between work and tool.
Dilip Chauhan said:
8 years ago
Yes, back rake angle is right.
Manikanta said:
8 years ago
Large positive side rake angle results in less chip formation.
Manoj said:
8 years ago
There are two rake angles, namely the back rake angle and side rake angle, both of which help to guide chip flow.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers