Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 1 (Q.No. 24)
24.
Side rake angle on tools is provided to control chip flow.
Discussion:
15 comments Page 1 of 2.
AlnME said:
2 years ago
Side rake angle on tools is provided to control chip flow and approach or side cutting angle control chip thickness.
Neeraj said:
5 years ago
It also controls flow of chips.
Ranjith said:
6 years ago
Rake angles are 2 types.
Back rake angle and side rake angle.
Both of them help to guide chip flow.
Back rake angle and side rake angle.
Both of them help to guide chip flow.
Kumar raja said:
7 years ago
Chip flow will be controlled by back rake angle only. Not by side rake angle.
Vijay Nokhwal said:
7 years ago
The Answer is wrong.
Side rake angle is for min contact to a job.
Side rake angle is for min contact to a job.
Manoj said:
8 years ago
There are two rake angles, namely the back rake angle and side rake angle, both of which help to guide chip flow.
Manikanta said:
8 years ago
Large positive side rake angle results in less chip formation.
Dilip Chauhan said:
8 years ago
Yes, back rake angle is right.
KOTI SRINUBABU said:
8 years ago
My opinion also same. Because side rake angles are relief angles to prevent rubbing action between work and tool.
Vishal said:
8 years ago
Yes, back rake angle.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers