Mechanical Engineering - IC Engines and Nuclear Power Plants - Discussion
Discussion Forum : IC Engines and Nuclear Power Plants - Section 1 (Q.No. 4)
4.
In hit and miss governing, the fuel supply is cut-off completely during one or more number of cycles.
Discussion:
17 comments Page 1 of 2.
SIT said:
1 decade ago
First we will look at the "Hit" state. This is really the same as the throttled engine except each time the engine intakes the gas it takes a full charge. There is no butterfly in a hit and miss mixer. So the engine wants to go faster and faster.
We will discuss how to "slow" the engine down or regulate it in the "Miss" section coming up.
We will discuss how to "slow" the engine down or regulate it in the "Miss" section coming up.
Lucky said:
8 years ago
A hit-and-miss engine is a type of four-stroke internal combustion engine that is controlled by a governor to operate a set speed. It was conceived in the late 19th century and produced by various companies from the 1890s through approximately the 1940s.
(3)
Jaimin said:
9 years ago
Centrifugal governor is used for cut off and supply fuel and this will happen by striker and steel rod.
If load on engine is increase then this governor increase the fuel supply and maintain constant speed of engine.
If load on engine is increase then this governor increase the fuel supply and maintain constant speed of engine.
Hemant said:
1 decade ago
Hit and Miss - Controls the engines speed by cutting off the engines ignition system when it runs too fast. This is the "miss" part. When the engine slows too much, it allows it to "hit" again and pick speed back up.
Ujjawal aggarwal said:
7 years ago
"Hit" and "Miss" is the condition of the governor when the sleeve of the governor is moving on its extreme positions (up and down). This is known as "hit and miss" governing.
(4)
Sugumaran said:
1 decade ago
What are the no.of cycles involved here? Answer please.
Prassanna said:
1 decade ago
If it controls the speed why cycles are involved in it?
S.Mahaboob Basha said:
9 years ago
What are their no of cycles in hit and miss governing?
Rahul said:
9 years ago
Centrifugal governor helps in governing the fuel.
Ram said:
1 decade ago
What is hit and miss governing and how it works?
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers