Civil Engineering - RCC Structures Design - Discussion
Discussion Forum : RCC Structures Design - Section 2 (Q.No. 41)
41.
If the diameter of longitudinal bars of a square column is 16 mm, the diameter of lateral ties should not be less than
Discussion:
37 comments Page 3 of 4.
Krishan dutt yadav said:
7 years ago
Yes, correct answer is 6mm.
Lalit kumar pandit said:
7 years ago
It is not less than 6mm.
Satya Prakash Malav said:
6 years ago
6 mm is the correct answer.
Jaan said:
6 years ago
Right answer is 6mm because in no case it should be less than 6mm.
Himansu Kunwar said:
6 years ago
WSM: 5mm minimum.
LSM : 6-mm minimum.
LSM : 6-mm minimum.
(1)
VPriya. said:
6 years ago
As per sp:30-1987 clause. 7.2.6.2.
The Dia of lateral ties shall not be less than 1/4th of dia of largest longitudinal bar & in no case less than 5 mm.
The Dia of lateral ties shall not be less than 1/4th of dia of largest longitudinal bar & in no case less than 5 mm.
Harish said:
6 years ago
The diameter of transverse reinforcement (lateral ties) is determined from cl.26.5.3.2 C-2 of IS 456 as not less than (i) φ /4 and (ii) 6 mm.
Here, φ = largest bar diameter used as longitudinal reinforcement = 20 mm. So, the diameter of bars used as lateral ties = 6 mm.
Here, φ = largest bar diameter used as longitudinal reinforcement = 20 mm. So, the diameter of bars used as lateral ties = 6 mm.
Bittu said:
6 years ago
The correct Answer is C) 6mm.
Engr Omid said:
6 years ago
The given answer is correct, Because the lateral ties dia is one-fourth of longitudinal bar dia..so here 1/4 *16=4 mm.
The imp condition is that it should be not less than 5mm according to Khurmi book..so answer is 5mm.
The imp condition is that it should be not less than 5mm according to Khurmi book..so answer is 5mm.
(1)
Vikrant said:
6 years ago
Minbar available is 8mm. So it would be 8mm.
(2)
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers