Civil Engineering - RCC Structures Design - Discussion
Discussion Forum : RCC Structures Design - Section 3 (Q.No. 50)
50.
The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than
Discussion:
31 comments Page 3 of 4.
Soumen said:
8 years ago
If the dia is 16 mm then stirrup is 5mm.
If the dia is 20 mm then 6 mm.
So, min is 5 mm.
If the dia is 20 mm then 6 mm.
So, min is 5 mm.
Ranesh said:
8 years ago
Yes, the correct answer is 6 mm.
Narya said:
8 years ago
According to IS code 5 mm.
Shivraj Nath said:
9 years ago
B is the correct one.
Mahendra kumar said:
9 years ago
6mm is correct or d/4 use both maximum values.
Ranjit ray said:
9 years ago
Yes, B is the correct answer.
Adnan said:
9 years ago
The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than 5mm.
Reference Book: civil engineering by R.S. Khurmi and J. K. Gupta.
Reference Book: civil engineering by R.S. Khurmi and J. K. Gupta.
RANJAN PATRA said:
9 years ago
Yes, 6MM is the correct answer.
Amol said:
10 years ago
5 mm correct but not used 5 mm bar use 6 mm bar.
Anu said:
10 years ago
6 mm is the correct.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers