Civil Engineering - RCC Structures Design - Discussion
Discussion Forum : RCC Structures Design - Section 3 (Q.No. 50)
50.
The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than
Discussion:
31 comments Page 1 of 4.
Abhishek said:
8 years ago
According to IS 456 cl 26.5.3.2 part C.2
The diameter of the polygonal links or lateral ties shall be not less than one fourth of the diameter of the largest longitudinal bar and in no case less than 16 mm.
Yes it says 16 mm
And books says 6 mm
I have checked the code on archive.org
Someone, please tell me why IS code saying 16 mm?
The diameter of the polygonal links or lateral ties shall be not less than one fourth of the diameter of the largest longitudinal bar and in no case less than 16 mm.
Yes it says 16 mm
And books says 6 mm
I have checked the code on archive.org
Someone, please tell me why IS code saying 16 mm?
Sidd said:
7 years ago
The correct answer is 7.
Listen, Dia should be maximum of 1/4th of dia or 6mm.
But it is given in QS that. If dia will b 1/4th of dia of the main bar then it means it can't be 6 mm. It can be 7 or greater than that. So the answer is D.
Listen, Dia should be maximum of 1/4th of dia or 6mm.
But it is given in QS that. If dia will b 1/4th of dia of the main bar then it means it can't be 6 mm. It can be 7 or greater than that. So the answer is D.
(1)
Adnan said:
9 years ago
The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than 5mm.
Reference Book: civil engineering by R.S. Khurmi and J. K. Gupta.
Reference Book: civil engineering by R.S. Khurmi and J. K. Gupta.
Soumen said:
8 years ago
If the dia is 16 mm then stirrup is 5mm.
If the dia is 20 mm then 6 mm.
So, min is 5 mm.
If the dia is 20 mm then 6 mm.
So, min is 5 mm.
Akash Awasare said:
8 years ago
The Correct Ans: 3) 6mm.
Remark: IS 456:2000, Cl. 26.5.3.2, c), 2).
Remark: IS 456:2000, Cl. 26.5.3.2, c), 2).
Ijom ninu nino said:
7 years ago
@Abhishek.
In IS code, 16 mm is just a misprinting, its 6mm.
In IS code, 16 mm is just a misprinting, its 6mm.
Uttam said:
8 years ago
As per working state method 5 mm.
Limit state method 6 mm.
Limit state method 6 mm.
Ritu said:
8 years ago
According to IS Code.
It was 5 mm and now it is 6 mm.
It was 5 mm and now it is 6 mm.
Rohan Mukherjee said:
5 years ago
6mm is the correct option as per IS CODE 456:2000.
Jivan shrestha said:
7 years ago
IS 456:2000, Cl. 26.5.3.2, c), 2).
So, it is 6mm.
So, it is 6mm.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers