Civil Engineering - RCC Structures Design - Discussion
Discussion Forum : RCC Structures Design - Section 3 (Q.No. 50)
50.
The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than
Discussion:
31 comments Page 2 of 4.
Er NK said:
7 years ago
Everyone, the answer is ---- not less than 5 mm.
Sidd said:
7 years ago
The correct answer is 7.
Listen, Dia should be maximum of 1/4th of dia or 6mm.
But it is given in QS that. If dia will b 1/4th of dia of the main bar then it means it can't be 6 mm. It can be 7 or greater than that. So the answer is D.
Listen, Dia should be maximum of 1/4th of dia or 6mm.
But it is given in QS that. If dia will b 1/4th of dia of the main bar then it means it can't be 6 mm. It can be 7 or greater than that. So the answer is D.
(1)
Vibha said:
7 years ago
You are right @Nino.
6mm is right.
6mm is right.
Ijom ninu nino said:
7 years ago
@Abhishek.
In IS code, 16 mm is just a misprinting, its 6mm.
In IS code, 16 mm is just a misprinting, its 6mm.
Jivan shrestha said:
7 years ago
IS 456:2000, Cl. 26.5.3.2, c), 2).
So, it is 6mm.
So, it is 6mm.
Abhishek said:
8 years ago
According to IS 456 cl 26.5.3.2 part C.2
The diameter of the polygonal links or lateral ties shall be not less than one fourth of the diameter of the largest longitudinal bar and in no case less than 16 mm.
Yes it says 16 mm
And books says 6 mm
I have checked the code on archive.org
Someone, please tell me why IS code saying 16 mm?
The diameter of the polygonal links or lateral ties shall be not less than one fourth of the diameter of the largest longitudinal bar and in no case less than 16 mm.
Yes it says 16 mm
And books says 6 mm
I have checked the code on archive.org
Someone, please tell me why IS code saying 16 mm?
Akash Awasare said:
8 years ago
The Correct Ans: 3) 6mm.
Remark: IS 456:2000, Cl. 26.5.3.2, c), 2).
Remark: IS 456:2000, Cl. 26.5.3.2, c), 2).
Uttam said:
8 years ago
As per working state method 5 mm.
Limit state method 6 mm.
Limit state method 6 mm.
Ritu said:
8 years ago
According to IS Code.
It was 5 mm and now it is 6 mm.
It was 5 mm and now it is 6 mm.
Silverheaven said:
8 years ago
According to IS code 5 mm correct.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers