Civil Engineering - RCC Structures Design - Discussion
Discussion Forum : RCC Structures Design - Section 2 (Q.No. 28)
28.
The length of lap in tension reinforcement should not be less than the bar diameter x (actual tension / four times the permissible average bond stress) if it is more than
Discussion:
8 comments Page 1 of 1.
Yuvaraj said:
9 years ago
In Horizontal 50D and in vertical 45D.
Chhaya said:
8 years ago
30dia as per IS 456 in tension.
24dia as per IS 456 In Compression.
24dia as per IS 456 In Compression.
Tarun Singh said:
7 years ago
Thanks @Chhaya.
Prabhu said:
6 years ago
@Chhaya.
In which clause of IS 456 is it given?
In which clause of IS 456 is it given?
Noora said:
6 years ago
Please explain the answer.
Priyanka Bhadra said:
5 years ago
It is based on Clause no. 26.2.5.1c.
Nick dongre said:
5 years ago
As per IS 456:2000;
For tension r/f = 30d.
For compression r/f = 24d.
For tension r/f = 30d.
For compression r/f = 24d.
B.Singh said:
3 years ago
1) Lap in Tension:
Flexural tension 30d, Ld
Direct tension 30d, 2Ld.
2) Lap in compression: 24d.
3) Straight length lap 15d or 200 mm.
Flexural tension 30d, Ld
Direct tension 30d, 2Ld.
2) Lap in compression: 24d.
3) Straight length lap 15d or 200 mm.
(3)
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers