Civil Engineering - GATE Exam Questions - Discussion
Discussion Forum : GATE Exam Questions - Section 1 (Q.No. 6)
6.
The wall shown in the below figure has failed. The cause of failure or the error made in the design of the failded wall is :
Discussion:
33 comments Page 1 of 4.
Antaryami said:
6 years ago
The CG of backfill will be just above the CG of retaining wall which tends to overturn it in an anticlockwise direction.
(6)
Girija said:
1 decade ago
The retaining wall caused by the soil pressure overcomes the overturning was had failed.
(1)
Ash said:
6 years ago
Weep holes are provided for drainage purpose, it is not a defect. Overturning is the correct answer.
(1)
Uday kumar said:
7 years ago
Retaining wall failed in overturning & sliding. So, the answer is B.
Ankitaray said:
9 years ago
How to overturn? please explain it.
Danish khan said:
9 years ago
In rainy season the water comes through weep cracks due to this the whole pressure comes on the wall.
Anup said:
9 years ago
Because backfill donot have wide rest (heal).
Arun said:
8 years ago
Imbalance of the i.e weak in bearing capacity do cause overturning, backfill should be given precisely so as to be effective.
Vinay singh said:
8 years ago
We can not decide the overturning moment here so it should be improper drainage.
Nireesha said:
8 years ago
How can you tell that it is only due to overturning?
In the given figure there are weep wholes so there is a defect in a vertical stem so this may be due to unfit conditions of backfill.
In the given figure there are weep wholes so there is a defect in a vertical stem so this may be due to unfit conditions of backfill.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers