Civil Engineering - GATE Exam Questions - Discussion
Discussion Forum : GATE Exam Questions - Section 1 (Q.No. 6)
6.
The wall shown in the below figure has failed. The cause of failure or the error made in the design of the failded wall is :
Discussion:
33 comments Page 1 of 4.
Dasarathi bhuyan Bhuyan said:
2 years ago
How it be overturning? Please explain it.
Pawan said:
3 years ago
If not clay it will be due to over turning. So the answer is C.
Madhu said:
5 years ago
Due to overturning wall and soil pressure, the structure becomes fail.
Pawan Pinto said:
6 years ago
Lack of backfill filter media can cause more pressure. Boulder backing is also an important criterion in case of mass concrete sections. Since this is a gravity wall. Due to the heavy earth behind and high backfill height, Overturning can be considered.
Antaryami said:
6 years ago
The CG of backfill will be just above the CG of retaining wall which tends to overturn it in an anticlockwise direction.
(6)
Ash said:
6 years ago
Weep holes are provided for drainage purpose, it is not a defect. Overturning is the correct answer.
(1)
Uday kumar said:
7 years ago
Retaining wall failed in overturning & sliding. So, the answer is B.
Daya said:
7 years ago
I cannot understand please explain in detail.
BHIMANAGOUD said:
7 years ago
Because of improper size the wall will get slide or overturned. So answer is over turning.
Nireesha said:
8 years ago
How can you tell that it is only due to overturning?
In the given figure there are weep wholes so there is a defect in a vertical stem so this may be due to unfit conditions of backfill.
In the given figure there are weep wholes so there is a defect in a vertical stem so this may be due to unfit conditions of backfill.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers