Civil Engineering - Concrete Technology - Discussion
Discussion Forum : Concrete Technology - Section 1 (Q.No. 1)
1.
For quality control of Portland cement, the test essentially done is
Discussion:
67 comments Page 3 of 7.
Taha said:
9 years ago
As per design. Usually the class of A1 is 1500 psi and A2 is 2500psi.
Chandrabose said:
9 years ago
In basic think, cement should have a binding property, so the quality control depends upon the compressive strength only. So, the compression test is enough.
S.hari nath gupta said:
9 years ago
All the above.
Because the setting time, soundness is very important.
Because the setting time, soundness is very important.
Ram chandra said:
9 years ago
Tensile strength does not consider at concreting member design.
Shakeel said:
9 years ago
Can anyone tell me the ratio of concrete class A1 & A2?
Muhammad Asif said:
9 years ago
1 - First of all raw material will be as per design (good quality).
2 - Concrete mixing is important.
3 - Slump test.
4 - Water Cement Ratio.
5 - Carry out the machine to place.
6 - Placing and vibrator.
7 - Time sitting.
8 - Curing.
9 - Compression test.
10 - Fall of height.
11 - Cube or cylindrical test.
12 - Consistency.
2 - Concrete mixing is important.
3 - Slump test.
4 - Water Cement Ratio.
5 - Carry out the machine to place.
6 - Placing and vibrator.
7 - Time sitting.
8 - Curing.
9 - Compression test.
10 - Fall of height.
11 - Cube or cylindrical test.
12 - Consistency.
Vijay said:
9 years ago
What is Fiber reinforced concrete?
Ken said:
9 years ago
What is the setting time for concrete?
What types of curing can I use?
What types of curing can I use?
Sawant chaitan said:
10 years ago
Tensile test for cement is not important.
Pavan langote said:
10 years ago
How to test for cement soundness?
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers