Technical Drawing - Traditional Drafting Techniques - Discussion
Discussion Forum : Traditional Drafting Techniques - General Questions (Q.No. 2)
2.
A line drawn with a long section, short dash, and another long section is a ________.
Discussion:
16 comments Page 1 of 2.
Tushar Khandare said:
8 years ago
But the long section then point then again long section is also a axis presentation, isn't it?
(1)
Anuj said:
1 decade ago
What is logic behind this. ?
Or its a normal angle arc question.
Or its a normal angle arc question.
Tracy said:
1 decade ago
A long section, short dash, and another long section is a representation of axis.
Parthiban said:
1 decade ago
It is the representation of axis.
Arun said:
1 decade ago
It standard representation of a basic center line in engg drawing.
Nitin khedekar said:
1 decade ago
Why it is called center axis of hidden cylinder?
Ashish said:
1 decade ago
It represents the axis as X-X.
Kumaraguru said:
1 decade ago
We can use centre lines for showing the centre of circle.
Digvijay Singh said:
1 decade ago
The center line has 6:1 ratio and it is used to represent center axis of any section.
Chand basha said:
1 decade ago
It is the general representation of the central axis for any object. Basics are very much important for everyone.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers