Technical Drawing - Traditional Drafting Techniques - Discussion
Discussion Forum : Traditional Drafting Techniques - General Questions (Q.No. 2)
2.
A line drawn with a long section, short dash, and another long section is a ________.
Discussion:
16 comments Page 1 of 2.
Tushar Khandare said:
8 years ago
But the long section then point then again long section is also a axis presentation, isn't it?
(1)
Avijit kundu said:
8 years ago
Why it specified for particular a hidden cylinder?
Selvakani said:
8 years ago
I can't understand it. Please explain briefly.
Sanjeevkumar k said:
9 years ago
The standard center hidden lines are indicated by short dashes and long lines in engineering drawing.
Alice Eke said:
10 years ago
What did they mean by long section?
Sunil said:
1 decade ago
We can't represent hidden part of object by continuous line so we have to used hidden lines it's systematic way to show hidden parts of object.
Louis said:
1 decade ago
I can't understand your explanations guys. Somebody explain the answer fully for me?
Chand basha said:
1 decade ago
It is the general representation of the central axis for any object. Basics are very much important for everyone.
Digvijay Singh said:
1 decade ago
The center line has 6:1 ratio and it is used to represent center axis of any section.
Kumaraguru said:
1 decade ago
We can use centre lines for showing the centre of circle.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers