IndiaBIX

Technical Drawing - Traditional Drafting Techniques - Discussion

Discussion Forum : Traditional Drafting Techniques - General Questions (Q.No. 7)
Traditional Drafting Techniques
7.
An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
1/4" = 1'-0"
1/8" = 1'-0"
1" = 100'
3/4" = 1'-0"
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Discussion:
4 comments Page 1 of 1.
AVIJIT KUNDU said:   8 years ago
Unable to understand it. Please clarify it properly.
Bishal Pokharel said:   7 years ago
Scale factor is always unity at the numerator.
Gat said:   1 decade ago
1 inch = 25.4mm

3/16 inch = ?

ans=4.7625
Kat said:   9 years ago
1 cm = 100 mm.
Post your comments here:

Your comments will be displayed after verification.

Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers