IndiaBIX

Technical Drawing - Traditional Drafting Techniques

Exercise : Traditional Drafting Techniques - General Questions
6.
In order to convert fractional inches into decimal inches ________.
look on a metric conversion chart
divide the numerator (top number) by the denominator (bottom number)
check the engineer's scale
all of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
7.
An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________.
1/4" = 1'-0"
1/8" = 1'-0"
1" = 100'
3/4" = 1'-0"
Answer: Option
Explanation:
No answer description is available. Let's discuss.
8.
Referring to the fractional inches to decimal inches to millimeter conversion chart on page 55 what is the equivalent mm measurement of 3/16 inch.
1.906
4.7625
5.958
14.6844
Answer: Option
Explanation:
No answer description is available. Let's discuss.
9.
Some traditional board drafters preferred the drafting machine over the parallel straight edge because it could be used without the need for________.
circle templates
triangles
technical pens
lettering guides
Answer: Option
Explanation:
No answer description is available. Let's discuss.
10.
The first step in creating a traditional technical drawing is to ________.
draw a series of guide lines
set up the miter line
align the paper so that it will be positioned square to the parallel bar
sharpen the leads in the technical pens
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers