IndiaBIX

Technical Drawing - Computer Aided Design Basics - Discussion

Discussion Forum : Computer Aided Design Basics - General Questions (Q.No. 1)
Computer Aided Design Basics
1.
Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________.
type @3<45 and enter
type 3 back slash and enter
type 3 forward slash and enter
type 3 and try to use the Dynamic Input readout to find the end point
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Discussion:
2 comments Page 1 of 1.
Sathish said:   1 decade ago
Because the formula for relative polar co-ordinate system is at (units) < (degree of inclination).
Karan said:   1 decade ago
Because its a standard technique for entering polar co ordinates in CAD.

"3" (units) "<" (angle i.e. > or <) "45" (degree of inclination).
Post your comments here:

Your comments will be displayed after verification.

Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers