Online Electronics Test - Electronics Test 4

Instruction:

  • This is a FREE online test. Beware of scammers who ask for money to attend this test.
  • Total number of questions: 20.
  • Time allotted: 30 minutes.
  • Each question carries 1 mark; there are no negative marks.
  • DO NOT refresh the page.
  • All the best!

Marks : 2/20


Total number of questions
20
Number of answered questions
0
Number of unanswered questions
20
Test Review : View answers and explanation for this test.

1.
The number 560,000 is expressed in scientific notation.
True
False
Your Answer: Option
(Not Answered)
Correct Answer: Option

2.

Which part of an atom has no electrical charge?

Electron
Neutron
Proton
All of the above
Your Answer: Option
(Not Answered)
Correct Answer: Option

3.
One coulomb passing a point in one second is one:
ampere
volt
ohm
charge
Your Answer: Option
(Not Answered)
Correct Answer: Option

4.
An 8-ohm resistor is in series with a lamp. The circuit current is 1 A. With 20 V applied, what voltage is being allowed for the lamp?
4 V
8 V
12 V
20 V
Your Answer: Option
(Not Answered)
Correct Answer: Option

5.
In a series circuit, the current flowing out of a resistor won't always equal the current flowing into that resistor.
True
False
Your Answer: Option
(Not Answered)
Correct Answer: Option

6.

The phase angle between the two waveforms in the given circuit equals _____.

75°
15°
105°
45°
Your Answer: Option
(Not Answered)
Correct Answer: Option

7.

If the frequency increases in the given circuit, how would the total current change?

The total current would increase.
The total current would decrease.
The total current would remain the same.
More information is needed in order to predict how the total current would change.
Your Answer: Option
(Not Answered)
Correct Answer: Option

8.
A step-up transformer will have a turns ratio greater than 1.
True
False
Your Answer: Option
(Not Answered)
Correct Answer: Option

9.

What is the current through the capacitor in the given circuit?

3.5 mA
5.5 mA
9 mA
11.4 mA
Your Answer: Option
(Not Answered)
Correct Answer: Option

10.
What is the true power consumed in a 30 V series RLC circuit if Z = 20 ohms and R = 10 ohms?
15.0 watts
22.5 watts
30.0 watts
45.0 watts
Your Answer: Option
(Not Answered)
Correct Answer: Option

11.
The ___ oscillator takes advantage of the piezoelectric effect.
crystal
Hartley
Colpitts
RC
Your Answer: Option
(Not Answered)
Correct Answer: Option

12.
A differential amplifier has a common-mode gain of 0.2 and a common-mode rejection ratio of 3250. What would the output voltage be if the single-ended input voltage was 7 mV rms?
1.4 mV rms
650 mV rms
4.55 V rms
0.455 V rms
Your Answer: Option
(Not Answered)
Correct Answer: Option

13.

Which circuit is known as a current-to-voltage converter?

a
b
c
d
Your Answer: Option
(Not Answered)
Correct Answer: Option

14.
One ampere of current flowing through one ohm of resistance is equal to:
1 horsepower
1 Btu
1 watt
1 joule
Your Answer: Option
(Not Answered)
Correct Answer: Option

15.
How many connections does a potentiometer have?
1
2
3
4
Your Answer: Option
(Not Answered)
Correct Answer: Option
Explanation:
A potentiometer uses three connections, as opposed to a rheostat, which only employs two. Having three connections allows the potentiometer to vary voltage. Both the potentiometer and the rheostat are classified as variable resistors.

16.
DC current flows in one direction, while ac current rises from zero to a maximum, then falls to zero in one direction, then rises to a maximum, then falls to zero in the opposite direction.
True
False
Your Answer: Option
(Not Answered)
Correct Answer: Option

17.
When and who discovered that more than one transistor could be constructed on a single piece of semiconductor material:
1949, William Schockley
1955, Walter Bratten
1959, Robert Noyce
1960, John Bardeen
Your Answer: Option
(Not Answered)
Correct Answer: Option

18.
In this analog amplifier the input is in phase with the output.

tfq12_1017_1.gif
True
False
Your Answer: Option
(Not Answered)
Correct Answer: Option

19.
The process of converting a decimal number to its binary equivalent is called binary conversion.
True
False
Your Answer: Option
(Not Answered)
Correct Answer: Option

20.
When the output of a standard TTL gate is HIGH, it can ___________________.
sink 16 mA of current from the attached input gates
source 400 mu.gifA of current to no more than 10 attached gates
source 16 mA of current to no more than 10 attached gates
sink a maximum of 400 mu.gifA from no more than 10 load gates
Your Answer: Option
(Not Answered)
Correct Answer: Option

*** END OF THE TEST ***
Time Left: 00:29:56
Post your test result / feedback here: