Online Biochemical Engineering Test - Biochemical Engineering Test 6

Instruction:

  • This is a FREE online test. Beware of scammers who ask for money to attend this test.
  • Total number of questions: 20.
  • Time allotted: 30 minutes.
  • Each question carries 1 mark; there are no negative marks.
  • DO NOT refresh the page.
  • All the best!

Marks : 2/20


Total number of questions
20
Number of answered questions
0
Number of unanswered questions
20
Test Review : View answers and explanation for this test.

1.
In a Lineweaver-Burk Plot, competitive inhibitor shows which of the following effect?
It moves the entire curve to right
It moves the entire curve to left
It changes the x-intercept
It has no effect on the slope
Your Answer: Option
(Not Answered)
Correct Answer: Option

2.
To measure the extent to which the reaction rate is lowered because of resistance to mass transfer, the effectiveness factor of an immobilized enzyme, η can be defined as
reaction rate/rate if not slowed by diffusion
rate if not slowed by diffusion/ reaction rate
actual reaction rate/ rate if not slowed by diffusion
rate if not slowed by diffusion/ actual reaction rate
Your Answer: Option
(Not Answered)
Correct Answer: Option

3.
Fluidized bed bioreactors provide higher mass transfer rates than packed bed bioreactors because
mixing is higher in fluidized bed bioreactors
particles move with the fluid in a fluidized bed bioreactor
immobilized particles are smaller in the fluidized bed bioreactors
all of the above
Your Answer: Option
(Not Answered)
Correct Answer: Option

4.
Yield coefficient represents
total biomass or product produced
conversion efficiency of a substrate into product
conversion rate of a substrate into biomass or product
production time of biomass or product
Your Answer: Option
(Not Answered)
Correct Answer: Option

5.
Which of the following would not be subjected to the "glucose effect"?
Aspergillus fumigatus
Saccharomyces cerevisiae
Escherichia coli
Aspergillus niger
Your Answer: Option
(Not Answered)
Correct Answer: Option

6.
Toxins accumulated in a reactor can lead to low biomass yields probably due to which of the following?
NAD+ is diverted away from homeostasis to anabolism
ATP is diverted away from homeostasis to anabolism
NAD+ is diverted away from anabolism to homeostasis
ATP is diverted away from anabolism to homeostasis
Your Answer: Option
(Not Answered)
Correct Answer: Option

7.
In the batch-fed mode, substrate will be added
only at the beginning of the fermentation process
periodically throughout the fermentation process
only at the end of the fermentation process
substrate is never added
Your Answer: Option
(Not Answered)
Correct Answer: Option

8.
A strain of Escherichia coli has a maximum specific growth rate of 0.8 h-1 on a glucose based medium. If this organism is being grown in a chemostat with a dilution rate of 1.2 h-1, then at steady state the concentration of E. coli in the same medium will
increase
be zero
change randomly
decrease
Your Answer: Option
(Not Answered)
Correct Answer: Option

9.
Which of the following is best described as secondary metabolite?
Acetic acid produced from the oxidation of ethanol
Ethanol from the fermentation of glucose
Penicillin
Citric acid from the partial oxidation of glucose
Your Answer: Option
(Not Answered)
Correct Answer: Option

10.
The contents in jet loop reactor are mixed through
compressed air
a mechanical agitator
external pumping
any of these
Your Answer: Option
(Not Answered)
Correct Answer: Option

11.
Wash out in steady state fermentation occurs when
dilution rate is less than maximum specific growth rate
dilution rate is higher than the maximum specific growth rate
cell concentration reaches the maximum
specific growth rate is maximum
Your Answer: Option
(Not Answered)
Correct Answer: Option

12.
The main function(s) of a draft tube in an air lift fermenter is/are to
increase the solubility of oxygen
distribute shear forces throughout the reactor and minimise bubble coalescence
concentrate shear forces around the sparger
concentrate shear forces near the disengagement zone
Your Answer: Option
(Not Answered)
Correct Answer: Option

13.
Which of the following impellers will provide radial flow?
Paddles
Flat blade turbines
Disk flat blade turbines
All of the above
Your Answer: Option
(Not Answered)
Correct Answer: Option

14.
To increase the oxygen transfer rate in a shake flask culture system, which of the following (s) is/are followed?
Liquid volume in the flask is reduced
Stirrer speed is increased
Baffled flasks are used
All of the above
Your Answer: Option
(Not Answered)
Correct Answer: Option

15.
During aeration, a cylindrical reactor had a height of 10 m. Without aeration, the height was 7.5 m. Under these aeration and mixing conditions, the gas hold up in the reactor is
100%
75%
50%
25%
Your Answer: Option
(Not Answered)
Correct Answer: Option

16.
The power required by an impeller in a gas sparged system compare to the power required by impeller operating at same speed in a gas free liquid is usually
lesser
higher
same
may be lesser or higher depending upon the geometry
Your Answer: Option
(Not Answered)
Correct Answer: Option

17.
The mechanical means of accomplishing sterilization of fermentation media/equipment is
ultrasonic
radiation
chemical agents
none of these
Your Answer: Option
(Not Answered)
Correct Answer: Option

18.
Analogus to the molecular diffusion, the x-directional flux of microorganisms suspended in a medium due to the axial mixing can be represented as (where Jn is flux component 'n', cn is concentration of'n')
Jn = -dcn/dx
Jn = dcn/dx
Jn = -D dcn/dx
Jn = D dcn/dx
Your Answer: Option
(Not Answered)
Correct Answer: Option

19.
The heat conduction in dry air is
less rapid than in steam
more rapid than in steam
similar to steam
none of these
Your Answer: Option
(Not Answered)
Correct Answer: Option

20.
Which of the following chemical is sometime added in the process of coagulation and flocculation?
Aluminum sulphate
Aluminum oxide
Calcium chloride
None of these
Your Answer: Option
(Not Answered)
Correct Answer: Option

*** END OF THE TEST ***
Time Left: 00:29:56
Post your test result / feedback here: