Networking - Managing a Cisco Internetwork - Discussion

Discussion :: Managing a Cisco Internetwork - Managing a Cisco Internetwork (Q.No.13)


You telnet into a remote device and type debug ip rip, but no output from the debug command is seen. What could the problem be?

[A]. You must type the show ip rip command first.
[B]. IP addressing on the network is incorrect.
[C]. You must use the terminal monitor command.
[D]. Debug output is sent only to the console.

Answer: Option C


To see console messages through your Telnet session, you must enter the terminal monitor command.

Post your comments here:

Name *:

Email   : (optional)

» Your comments will be displayed only after manual approval.