Networking - IPv6 - Discussion

Discussion :: IPv6 - IPv6 (Q.No.4)

4. 

What multicast addresses does RIPng use?

[A]. FF02::A
[B]. FF02::9
[C]. FF02::5
[D]. FF02::6

Answer: Option B

Explanation:

RIPng uses the multicast IPv6 address of FF02::9. If you remember the multicast addresses for IPv4, the numbers at the end of each IPv6 address are the same.

Yogesh Singh said: (Apr 22, 2018)  
Ff02::1 All nodes on the local network segment.
Ff02::2 All routers on the local network segment.
Ff02::5 OSPFv3 All SPF routers.
Ff02::6 OSPFv3 All DR routers.
Ff02::8 IS-IS for IPv6 routers.
Ff02::9 RIP routers.
Ff02::a EIGRP routers.
Ff02::d PIM routers.
Ff02::16 MLDv2 reports (defined in RFC 3810).
Ff02::1:2 All DHCP servers and relay agents on the local network segment (defined in RFC 3315).
Ff02::1:3 All LLMNR hosts on the local network segment (defined in RFC 4795).
Ff05::1:3 All DHCP servers on the local network site (defined in RFC 3315).
Ff0x::c Simple Service Discovery Protocol.
Ff0x::fb Multicast DNS.
Ff0x::101 Network Time Protocol.
Ff0x::108 Network Information Service.
Ff0x::181 Precision Time Protocol (PTP) version 2 messages (Sync, Announce, etc. ) except peer delay measurement.
Ff02::6b Precision Time Protocol (PTP) version 2 peer delay measurement messages.
Ff0x::114 Used for experiments.

Post your comments here:

Name *:

Email   : (optional)

» Your comments will be displayed only after manual approval.