Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 1 (Q.No. 10)
10.
In a bilateral system of tolerance, the tolerance is allowed on
Discussion:
14 comments Page 1 of 2.
Kumar ellapu said:
1 decade ago
Bilateral system of tolerance means both sides of the nominal size i.e. Actual size means the manufacturer after the manufacturing that becomes a actual size before manufacturing that should be consider as a nominal size. At that condition sizes from both sides of the nominal size.
Kumar ellapu said:
1 decade ago
Bilateral system of tolerance means both sides of the nominal size i.e. Actual size means the manufacturer after the manufacturing that becomes a actual size before manufacturing that should be consider as a nominal size. At that condition sizes from both sides of the nominal size.
Ramakrishna said:
9 years ago
Nominal size is the dimension of the object which is derived from the strength of material equations. But in practice achieving 100% accuracy is not possible. Hence tolerance is provided. The actual dimension of the object after machining is known as actual size.
(1)
Sohel said:
9 years ago
@Dhruv.
Nominal size can be referred as the maximum dimension of the component. While actual size is slightly smaller than the nominal size.
Nominal size can be referred as the maximum dimension of the component. While actual size is slightly smaller than the nominal size.
Shantagouda said:
1 decade ago
Bilateral tolerance is tolerance in which variation is permitted in both direction from the specified direction.e.g. 20 +0.060/-0.060.
Shiva said:
7 years ago
Nominal or basic size is a round off no nearest to actual size and the tolerances are provided on nominal size to get the actual size.
(1)
Prakurti said:
8 years ago
Actual size is slightly less than nominal size. After machining we get actual size of component, before machining it's nominal size.
(1)
Ishwar chandra said:
1 decade ago
In bilateral system tolerance is allowed on both side but in unilateral system tolerance is in only one direction.
Niranjan.Mech said:
8 years ago
Nominal size refer to designed dimension and actual dimension refers to final product dimension after machining.
Nayan said:
6 years ago
But in Unilateral system of tolerance means one side of the nominal size.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers