Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 4 (Q.No. 29)
29.
V-block is used to
Discussion:
13 comments Page 2 of 2.
Rishi Raj said:
5 years ago
The answer should be locate centre of round bar because we use V block and height gauge to check a centre of round rod.
Prathap said:
5 years ago
Without other equipment, (ie. For operation surface roughness checking, locate of center) V blocks does nothing. The point of view only (mainly) V blocks used for holding the round bar.
Aman said:
5 years ago
I think option B is right.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers