Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 4 (Q.No. 29)
29.
V-block is used to
Discussion:
13 comments Page 1 of 2.
Ggjadhav said:
1 decade ago
Specially v-block is used for holding round/circular cross sectional bar.
Ravi gawale said:
9 years ago
The V block are used to check roundness of the circular bar.
S.k.gupta said:
9 years ago
V-block is a locating device which is used to hold the round bars. Due to v-shape, it can hold easily round bars.
Harshit said:
7 years ago
What is used to measure the surface roughness and trueness of flat surface?
Mahesh said:
7 years ago
@Harshit.
Angle plate is used for trueness.
Angle plate is used for trueness.
Vaibhav said:
7 years ago
It is used to locate cylindrical surface.
Anoms said:
7 years ago
It's also used to check the roundness of the cylinder.
Tirumal reddy said:
6 years ago
It is used for checking the roundness. So, C is answer.
Rahul Kumar sahu said:
6 years ago
How answer is none of these because we use v-block to location center of cylinder workpiece in the fixture.
(1)
Rishi Raj said:
5 years ago
The answer should be locate centre of round bar because we use V block and height gauge to check a centre of round rod.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers