Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 1 (Q.No. 28)
28.
When a hole or cavity to be cored is not in line with the parting surface, then a __________ is used.
Discussion:
14 comments Page 1 of 2.
CHANDAN SHARMA said:
9 years ago
Horizontal core, vertical core, and balance core all are generally lies on the parting line between drag and cop box.
But drop core (other names are wire core, saddle core, tail core) is generally lies above or below the parting line.
So (drop core is the correct answer).
But drop core (other names are wire core, saddle core, tail core) is generally lies above or below the parting line.
So (drop core is the correct answer).
(2)
Raj said:
10 years ago
Horizontal cores, vertical core, balanced core, and also drop core, are there drop core is used when the hole is not in same line of parting surface.
Sohel said:
9 years ago
Drop core is used when the hole is above or below the parting line. It is also known as wing core, tail core, chair core and saddle core.
(1)
Keshav said:
6 years ago
Parting line means the line at which two die halves are meet in otherwords the line at which core and cavity meet.
Md Arbaj said:
6 years ago
What do you mean by drill hole below or above Parting line?
(1)
Gopala krishnan said:
1 decade ago
Please explain drop and balance core clearly.
Kiran said:
10 years ago
Hello please explain about drop core clearly.
Sushilkumargupta said:
10 years ago
Anyone can explain types of core please?
Lohith said:
1 decade ago
Please explain drop core clearly.
Lucky said:
7 years ago
Where it is used? Please explain.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers