Mechanical Engineering - Strength of Materials - Discussion
Discussion Forum : Strength of Materials - Section 6 (Q.No. 23)
23.
The perpendicular distance between the centre lines of the successive rows, is called pitch.
Discussion:
10 comments Page 1 of 1.
Shyamal dash said:
1 decade ago
I think answer is wrong. The perpendicular distance between rows of center line is called pitch.
Vimal said:
9 years ago
Dear @Shyamal the given answer is correct.
TRANSVERSE PITCH/ BACK PITCH - The perpendicular distance between centerlines of the successive rows.
PITCH - It is the distance from the center of one rivet to the center of the next rivet measured parallel.
TRANSVERSE PITCH/ BACK PITCH - The perpendicular distance between centerlines of the successive rows.
PITCH - It is the distance from the center of one rivet to the center of the next rivet measured parallel.
DN BHASKAR said:
9 years ago
You are correct @Vimal.
Abish gupta said:
9 years ago
Please give the correct answer with an explanation.
Priya said:
8 years ago
Great explanation, Thanks @Abish & @Vimal.
Priya said:
8 years ago
Thank you again @ Vimal & @Abish.
Ayan said:
8 years ago
This is back pitch.
Shivam said:
7 years ago
Well explained, Thanks.
Ritesh Kumar Singh said:
7 years ago
Anyone Please explain with figure.
AruN SharMa said:
4 years ago
Great explanation, Thanks @Vimal.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers