Mechanical Engineering - Strength of Materials - Discussion
Discussion Forum : Strength of Materials - Section 2 (Q.No. 11)
11.
For a 25 mm hole drilled in plates, the diameter of rivet shank should be
Discussion:
12 comments Page 1 of 2.
Naga Manu ase said:
5 years ago
From the formula.
Hole dia = dia of rivet + 2mm,
for dia of rivet > 25mm.
25mm - 2mm = dia of rivet.
Dia = 23mm.
Hole dia = dia of rivet + 2mm,
for dia of rivet > 25mm.
25mm - 2mm = dia of rivet.
Dia = 23mm.
(8)
Brajesh said:
6 years ago
Answer would be 21 mm.
Shank dia = 0.84 * hole dia.
Shank dia = 0.84 * hole dia.
Bharath said:
6 years ago
The size of the drilled hole in plates for riveting is 1.5 to 2mm larger than the dia of the rivet.
Vignesh Kuppuraj said:
6 years ago
Please expalin how?
R p said:
7 years ago
How? Explain.
Rohit said:
7 years ago
Size of rivet hole is greater than shank diameter therefore drilled hole is 25mm and shank diameter is less than 25mm then answer is 23mm.
Pradyumn said:
8 years ago
Shank diameter = .85 * dia of hole
According to V.B. Bhandari book.
According to V.B. Bhandari book.
Vyom said:
9 years ago
It should be 24 mm as per IS:1928 - 1961.
(1)
Rahul kumar said:
9 years ago
Actually, this value has come from data handbook, sometimes rivet hole is 1mm less and sometimes it is 2mm.
Bhupendra rawat said:
1 decade ago
According to me it should be 24.5 because diameter of shank should be less than shank approx 2 mm but in option has only 24.5.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers