Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 4 (Q.No. 17)
17.
Ultra-sonic machining is best suited for
Discussion:
2 comments Page 1 of 1.
Dhiru said:
1 decade ago
1 - It is best suited for tool steels, sintered carbides, glass, plastics & diamond etc.
2 - It is used for machining of hard & brittle materials.
3 - It cut materials at very slow speed & produces good surface finish.
4 - The vibrating tool made of brass & copper.
5 - The metal is removed by using abrasive slurry b/w the tool& work.
6- The abrasive slurry contains fine particles of Al oxide or silicon carbide or boron carbide &water.
2 - It is used for machining of hard & brittle materials.
3 - It cut materials at very slow speed & produces good surface finish.
4 - The vibrating tool made of brass & copper.
5 - The metal is removed by using abrasive slurry b/w the tool& work.
6- The abrasive slurry contains fine particles of Al oxide or silicon carbide or boron carbide &water.
(3)
RAJ said:
9 years ago
Nice points @Dhiru.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers