Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 4 (Q.No. 31)
31.
Gears can be best produced on mass production by
Discussion:
7 comments Page 1 of 1.
Ganeshr said:
5 years ago
I agree with you @Pankaj .
Sohan said:
7 years ago
It is Widely used for mass production of gears except internal gears or gears with shoulders and flanges because of the clearance needed for the job.
And I agree @Pankaj.
And I agree @Pankaj.
Mohit said:
8 years ago
Casting for Job/batch production
Biren said:
8 years ago
@Pankaj.
But it does not consider that for in terms of accuracy it's all about the mass production so I think casting is the right option.
But it does not consider that for in terms of accuracy it's all about the mass production so I think casting is the right option.
(1)
Pankaj said:
8 years ago
Hobbing can also be used for mass production and with more accuracy, through single rotation of blank all teeth can be prepared by hob, hobbing can be used for manufacturing spur, helical, worm gear and not used for bevel gear.
(2)
Rakesh said:
9 years ago
I think it's casting.
Rafi said:
9 years ago
Then what about Casting?
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers