Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 5 (Q.No. 19)
19.
The cutting speed is zero at the periphery and it is maximum at the centre of the drill.
Discussion:
4 comments Page 1 of 1.
Himanshu said:
6 years ago
Drilling operation is done by oblique cutting hence cutting speed and chip thickness is same in all directions.
(1)
GANESH said:
7 years ago
Explain it.
Anwar said:
6 years ago
Then how the cutting edge of a drill varies from point to point on the cutting edge?
Udith said:
6 years ago
At the center of the chisel edge the cutting speed is zero; at any point on the lip it is proportional to the radius of that point.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers