Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 8 (Q.No. 45)
45.
The cutting speed for counter-boring should be __________ that of drilling operation.
Discussion:
11 comments Page 1 of 2.
Ashish Gupta said:
10 years ago
Can any one explain why?
Mak said:
8 years ago
I think B is the correct answer.
S singh said:
8 years ago
Speed of counter boring is half of that of drilling.
Pooja said:
8 years ago
But if speed is more than finishing will not be good and boring is an enlarging operation in which finishing is high so how option C is correct?
(2)
Prafull said:
8 years ago
It is Less than 0.25 times drilling operation.
GOURANGA SAHOO said:
8 years ago
The correct answer is B.
Anudeep said:
7 years ago
Option B is correct because with an increase in dia speed increases whereas for spindle speed decrease.
Rajat bhardwaj said:
7 years ago
B) cutting speed of couterboring and countersinking is atlest 25% lesser than that of drilling.
Walter said:
7 years ago
B. Less than is right.
Manish said:
5 years ago
Counterboring produces finish hole and drilling produces rough hole followed by reaming so with high speed surface finish is good.
(1)
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers