Mechanical Engineering - Production Engineering - Discussion

Discussion Forum : Production Engineering - Section 2 (Q.No. 5)
5.
The lathe spindles are usually made hollow and provided with
internal taper
external taper
internal and external taper
no taper
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Discussion:
12 comments Page 1 of 2.

Vinay said:   4 years ago
The lathe spindles having external screw threads and Internal Taper.
(2)

Rahul prajapati said:   5 years ago
Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe centre or a tool such as a twist drill.
(1)

Sachin sharma said:   5 years ago
The spindle is hollow and has an internal Morse taper at the nose end, which makes possible the use of taper shank drills or drill chucks. This internal taper is also used to hold live centers, drive centers, or collet assemblies. The outside of the spindle nose can have either a threaded, a long taper with key drive, or a camlock.

Prof.umesh/tatva said:   6 years ago
The lathe spindles having external screw threads and Internal Taper.

Umesh said:   6 years ago
A) Internal taper is the right answer.

Jagadeesh said:   6 years ago
The external taper is the correct option.
(1)

Rajashekar said:   6 years ago
External taper is correct.

Rupesh farkade said:   6 years ago
External taper is correct.

Sudharshan said:   7 years ago
Why not external taper?

Vinod said:   8 years ago
Lathe spindle-external taper.


Post your comments here:

Your comments will be displayed after verification.