Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 6 (Q.No. 40)
40.
In American Standard Association (A S A) system, if the tool nomenclature is 8-6-5-5-10-15-2 mm, then the side rake angle will be
Discussion:
12 comments Page 1 of 2.
Shivam said:
4 years ago
Thanks @Jai Maurya.
Rajendra said:
6 years ago
Thanks all of you.
Kukku said:
6 years ago
Thanks @Mohd Taha.
Somnath Singha said:
7 years ago
Please explain the answer in detail.
Dwaipayan said:
7 years ago
In the other two systems (ORS and NRS), the inclination angle comes first.
Dwaipayan said:
7 years ago
Only in ASA system side rake, back rake, side clearance, auxiliary back clearance, end cutting edge, approach, nose radius (inch).
Ref. Machining and Machine tool by A. B. CHATTOPADHYAY.
Ref. Machining and Machine tool by A. B. CHATTOPADHYAY.
Venkat said:
8 years ago
No @Jai Maurya.
The Answer is Back rack angle, side rack angle, end relief angle, side relief angle, end cutting edge, side cutting edge, nose radios.
The Answer is Back rack angle, side rack angle, end relief angle, side relief angle, end cutting edge, side cutting edge, nose radios.
Mohd Taha said:
9 years ago
RRC= Rake, Relief, Cutting Edge.
(1)
Bhavesh Shingala said:
9 years ago
Back rake angle, Side rake angle, Front or end clearance or relief angle, Side clearance angle or relief angle, End cutting edge angle, Side cutting edge angle, Nose radius.
Mohan Naik said:
9 years ago
Please describe it with the nomenclature diagram.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers