Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 6 (Q.No. 40)
40.
In American Standard Association (A S A) system, if the tool nomenclature is 8-6-5-5-10-15-2 mm, then the side rake angle will be
Discussion:
12 comments Page 2 of 2.
Jai maurya said:
1 decade ago
Back rake angle, side rake angle, end cutting edge angle, side cutting edge angle, end relief angle, side relife angle, noge radius.
Anoop said:
1 decade ago
Please explain this answer.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers