Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 1 (Q.No. 20)
20.
The rake angle required to machine brass by high speed steel tool is
Discussion:
11 comments Page 1 of 2.
Chakri said:
10 years ago
All soft materials should machine at zero rake angle?
(1)
Sekhar said:
1 decade ago
Brass is soft material. Due to this reason we are using then high speed with zero rake.
Vikas said:
1 decade ago
Good surface finish is obtained with zero rake angle while machining brass with HSS tool.
Shikandar Prasad said:
9 years ago
For brittle materials negative rake angle required & for ductile materials positive rake angle required for machining brass is in between of above two materials so for brass we use zero rake angle.
Pranav said:
9 years ago
If rake angle is zero then there will be excess tool wear.
How can you provide that much?
How can you provide that much?
Atul said:
7 years ago
For cast iron and brass zero rake angle is used.
Ideally zero rake angle can be applied to any material.
Ideally zero rake angle can be applied to any material.
Hardik Bhano said:
7 years ago
Brass is the soft material so 0 rake angle.
Yuvraj said:
6 years ago
Because of sticking tendency of brass we use 0 rake angle.
Biswajit said:
6 years ago
Generally rake angle has not so impact on surface finish but in case of brass keeping all parameter same if we provide 0 rake angle we can achieve great surface finish.
Salahuddin said:
6 years ago
Brass is a special case.
I agree with @Shikander prasad.
I agree with @Shikander prasad.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers