Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 1 (Q.No. 33)
33.
In oblique cutting system, the maximum chip thickness occurs at the middle.
Discussion:
9 comments Page 1 of 1.
Sheik israel said:
8 years ago
In orthogonal cutting system, the maximum chip thickness occurs at the middle.
(1)
Parveen said:
9 years ago
Yes, absolutely right Middle is maximum.
(2)
Yatharth said:
9 years ago
In oblique cutting, the maximum chip thickness may not occurs at the middle because the cutting edge of the tool is inclined at an acute angle with the direction of tool feed or work feed. Thus the thickness of the chip coming out is equal in each sides. Drilling comes under the oblique cutting, which shows the good example.
(3)
Gopinath said:
9 years ago
Oblique cutting is a type of metal cutting operation. In which cutting edge of the tool is straight and inclined to the direction of tool or work travel. This helps chips to flow easily.
Zafar said:
1 decade ago
When the chip does not flow on orthogonal plane i.e. chip deviates from orthogonal plane then it is called oblique cutting.
Indramani said:
1 decade ago
Please give technical answer.
Manoj Katiyar said:
1 decade ago
All side chip thickness equal in oblique cutting operations.
Banty said:
1 decade ago
In orthogonal cutting i.e. 90 deg cutting chip thickness is in middle while in oblique it may be anywhere.
Arun said:
1 decade ago
In oblique cutting operation, all sides the chip thickness are equal.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers