Mechanical Engineering - Machine Design - Discussion
Discussion Forum : Machine Design - Section 1 (Q.No. 15)
15.
According to I.B.R., shearing resistance required to shear off the rivet per pitch length (in double shear) is (where n = Number of rivets per pitch length)
d2 x τ x n1.875 x d2 x τ x n
d2 x τ x n2 x d2 x τ x n
d2 x τ x n3 x d2x τ x n
d2x τ x nDiscussion:
10 comments Page 1 of 1.
Ganeshr said:
5 years ago
@Swati.
I agree with you. Thanks.
I agree with you. Thanks.
Sanju said:
7 years ago
It should be twice as approximately.
(1)
Pabitra said:
8 years ago
IBR =indian boiler regulation.
(1)
KOTI SRINUBABU said:
8 years ago
There is shear acting on two surfaces of rivets, it should be twice of the area, but practically found as 1.875 times.Because two plates are not the same thickness
i.e strap thickness is 0.75t.
i.e strap thickness is 0.75t.
Nilesh ingle said:
9 years ago
Yeah, it is near about twice.
Shubham sharma said:
10 years ago
Yup its should be twice as approximately and given in most of books.
Mani kumar said:
1 decade ago
Actually it is twice but for design purpose it was considered as 1.875.
(1)
Swati said:
1 decade ago
There is shear acting on two surfaces of rivets, it should be twice of area, but practically found as 1.875 times.
Maadaswamy B said:
1 decade ago
IBR means Indian Boiler Regulations.
Vineet said:
1 decade ago
Friends, what is IBR?
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers