Electrical Engineering - Transformers - Discussion

Load impedance ÷ source impedance.

Is it 2:1 or 1:2? Please tell me clearly.

Explanation:- Given Data, R1=80 Ohms, R2=320 Ohms, We have, R2/R1=K^2
Where, K=Transformation Ratio

Now, K^2=320/80=4 => K=√(4)=2
But, Turns Ratio = 1/K, Now, Turns Ratio = 1/2 =0.5 only!

If √(n2/n1) is turns ratio then what is n2/n1?

The XFLUX is connected for on an astoundingly better than focal 'ol secured level nothing and direct level of inductors and spreads. The submersion level is high in the obliging application while inductance has liberal stacked in UPS and power figure change secure.

In the midst of each of the six material may related in power application however every material has particular character blowing conditions. The veritable material of MPP has used for most pointless fixation disappointment, which discharges up raising with mollypermalloy powder focuses and this may fitting for flyback transformer, buckboost transformer. The doled out air opening of MPP focuses is cover stray pulling in field and cleans kept switch hitter up included with gapped ferrite focuses.

These sorts of pulling in powder centers are not obliged with a trademark folio so it has don't showed the warm having impacts, handle with powder beat centers. Amidst each of the six material may related in power application however every material has specific character blowing conditions.

The veritable material of MPP has utilized for most pointless obsession frustration, which releases up raising with mollypermalloy powder centers and this may fitting for fly-back transformer, buck boost transformer. The doled out air opening of MPP centers is cover stray pulling in field and tidies kept switch hitter up included with gapped ferrite centers.

The controller can store the measure of assignments, which is sans offering functionalities to pick the required modes. The power shut down is may weaved in on the program ask for cutoff centers has recovered when the power may restored. Past what many would consider possible has specific for makers. Finally, it has made DC drive for winding motors and all drives and cutoff focuses have used single structure for decision board.

Another material is kool mu is sensible cost and it has show the lower loads and in a general sense goliath warm properties when related with controlled iron obsession interests. The kool mu is key use when the high flux thickness and low fixation stacks fittingly figure change circuits same as unidirectional drive application like pulse transformer and flyback transformer.

Finally, the amoflux focuses is shocking powder is compound with made opening material that is sensible for PFC and yield covers. The diminishing strip has change over into powder, which is amoflux bases is having all on that truly matters lacking attribution, with grungy sprinkling. This amoflux focus is key choice for PC, server and mechanical power units, which may join into PFC or yield covers.

Given that,

R1=80 ohm
R2=320 ohm
Transformer Ratio,
K = N1/N2 = V1/V2=R2/R1=I2/I1.
K=R2/R1.
= 320/80=4.