IndiaBIX

Computer Science - Computer Hardware

Exercise : Computer Hardware - Section 2
26.
To install a second IDE drive into a computer, you must:
Set the master-slave jumper to slave on the second drive
Use the IDE configuration software to set the new drive as slave
Verify that you define the new drive as D: in the CMOS setup
Verify that you attach the drive to the connector at the end of the ribbon cable
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
27.
Why does a successfully mapped network drive disappear every time you boot the computer?
The computer you are connected to has moved
You didn't click reconnect on log on
The map statement is not in the autoexec.bat file
The last drive was not set correctly
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
28.
What do you need to check serial and parallel port?
Port adapter
Logic probe
Loopback plug
All of the above
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
29.
You have a PC with no video* Which of the following is LEAST likely to be causing the problem?
defective RAM (bank zero)
defective microprocessor
crashed hard drive
loose video card
low AC outlet power
Answer: Option
Explanation:
No answer description is available. Let's discuss.
30.
To test for AC ripple on a PC power supply, you would set the volt/ohm meter for:
DC voltage scale
AC voltage
OHM scale
Farad scale
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers